Setup USB connection on your Mac
- Download this software:
- If Capture package:
eBeam Capture 1.3.5.1 for Mac OSX (10.4, 10.5, 10.6)
- If Projection package:
eBeam Interact 1.3.5.1* for Mac OSX (10.4, 10.5, 10.6)
*Only works with USB. For Bluetooth troubleshooting, please refer to Luidia's Known Issues page.
- If Complete package:
eBeam Capture 1.3.5.1 for Mac OSX (10.4, 10.5, 10.6)
eBeam Interact 1.3.5.1* for Mac OSX (10.4, 10.5, 10.6)
*Only works with USB. For Bluetooth troubleshooting, please refer to Luidia's Known Issues page.
- Unzip the software, open the dmg file and start the install process.
- When complete go to Applications in the Finder window and look for the eBeam icons - drag them to your dock if you wish.
- Take the included USB cable and plug it into your eBeam and plug the other end into your computer.
- Position the eBeam at the top left or right corner of your whiteboard with one of the included mounting brackets.
Note: be sure it is at a 90 degree angle in relation to the writing surface.
- If your eBeam package is Projection or Complete connect your computer to a projector and position the projected area so the mounted eBeam is 1-3 inches off the top left or right corner.
- Mac OS X will automatically configure the connection (eBeam pod light should be green).
- Start eBeam Interact or eBeam Capture and calibrate.
Attention: We recommend following the Naming eBeam - PDF instructions and affixing a physical label with the same name you specify to the eBeam pod.
Your eBeam is now setup! We highly recommend training to realize the full potential of your eBeam. Please contact us to schedule an on-site or online training session. (use contact form)
